Harbor Freight Tools 20 ton Log Splitter Instrukcja Obsługi Pobierz pdf (Strona 13)

Page 13For technical questions, please call 1-888-866-5797.ITEM 61594

SAFETYOPERATIONMAINTENANCE SETUP

2. Open the Fuel Valve.

3. Slide the Throttle or Speed Control Lever to 1/3

away from the SLOW position (the “turtle”).

4. Turn the Engine Switch on.

5. Grip the Starter Handle of the Engine loosely and pull

it slowly several times to allow the gasoline to flow into

the Engine’s carburetor. Then pull the Starter Handle

gently until resistance is felt. Allow Cable to retract fully

and then pull it quickly. Repeat until the engine starts.

Note: Do not let the Starter Handle snap back against the engine.

Hold it as it recoils so it doesn't hit the engine.

6. Allow the Engine to run for several seconds.

Then, if the Choke lever is in the CHOKE position,

move the Choke Lever very slowly to its RUN position.

Note: Moving the Choke Lever too

fast could stall the engine.

IMPORTANT: Allow the engine to run at no load for five minutes

with no load after each start-up so that the engine can stabilize.

7. Adjust the Throttle as needed.

OFF

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Brak uwag

Harbor Freight Tools 20 ton Log Splitter Instrukcja Obsługi Strona 13