Harbor Freight Tools Variable Speed Multifunction Air Tool Instrukcja Obsługi Pobierz pdf (Strona 8)

Page 8For technical questions, please call 1-800-444-3353.SKU 67538

Quick

Coupler

Recommended Air Line Components

Regulator with

Pressure Gauge

Quick

Coupler

Air Hose

on Reel

Valve FilterOiler

Coupler

Plug

Tool

Air

Compressor

Coupler

Plug

Incorporate a lter, regulator with 1.

pressure gauge, oiler, in-line shutoff

valve, and quick coupler for best

service, as shown in the diagram

above. An in-line shutoff ball

valve is an important safety device

because it controls the air supply

even if the air hose is ruptured.

The shutoff valve should be a ball

valve because it can be closed

quickly.

Note: If an automatic oiler system is not

used, add a few drops of Pneumatic

Tool Oil to the airline connection

before operation. Add a few more

drops after each hour of continual

use.

Attach an air hose to the 2.

compressor’s air outlet. Connect the

air hose to the air inlet of the tool.

Other components, such as a coupler

plug and quick coupler, will make

operation more efcient, but are not

required.

WARNING! TO PREVENT SERIOUS

INJURY FROM ACCIDENTAL

OPERATION:

Do not install a female quick

coupler on the tool. Such a coupler

contains an air valve that will allow

the air tool to retain pressure and

operate accidentally after the air

supply is disconnected.

Note: Air ow, and therefore tool

performance, can be hindered by

undersized air supply components.

The air hose must be long enough 3.

to reach the work area with enough

extra length to allow free movement

while working.

Turn the tool’s throttle or switch to the 4.

off position; refer to Operation section

for description of controls.

Close the in-line safety valve between 5.

the compressor and the tool.

Turn on the air compressor according 6.

to the manufacturer’s directions and

allow it to build up pressure until it

cycles off.

Adjust the air compressor’s output 7.

regulator so that the air output is

enough to properly power the tool,

but the output will not exceed the

tool’s maximum air pressure at any

time. Adjust the pressure gradually,

while checking the air output gauge

to set the right pressure range.

Inspect the air connections for leaks. 8.

Repair any leaks found.

If the tool will not be used at this 9.

time, turn off and detach the air

supply, safely discharge any

residual air pressure, and release

the throttle and/or turn the switch to

its off position to prevent accidental

operation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag