Harbor Freight Tools 12 Volt 1/4 in. Lithium_Ion Cordless Hex Impact Driver Instrukcja Obsługi Pobierz pdf (Strona 7)

Page 7For technical questions, please call 1-888-866-5797.Item 68568

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY

INFORMATION section at the beginning

of this manual including all text

under subheadings therein before

set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM

ACCIDENTAL OPERATION: Unlock and release

the Trigger and disconnect Battery Pack before

adjusting tool or installing accessories.

Charging

1. Place the Battery Pack on a dry fireproof surface in

a room where the temperature is from 50–104° F.

Note: If recharging a newly spent Battery Pack,

allow it to cool completely before charging.

Make sure the Battery Pack is undamaged;

do not charge a cracked or leaking battery pack.

2. Plug the Power Cord into the Charger. Then plug the

Power Cord into a grounded, 120 VAC, 60 Hz outlet.

The green charging light will activate, showing

that power is supplied to the Charger.

3. Slide the Battery Pack onto the Charger’s base.

The red charging indicator light will activate

to show that charging is taking place.

Note: The Battery Pack’s capacity will increase somewhat

during the first few charging cycles. A fully discharged

battery will take about 75 minutes to fully charge.

CAUTION! Recharging the Battery Pack for more

than 75 minutes can damage the battery cells.

4. While charging, the Battery Pack and Charger

may become warm to the touch. This is

normal, and does not indicate a problem.

5. Unplug Charger and disconnect from

Battery Pack when finished.

6. Allow the Battery Pack to cool completely before use.

7. Press the Battery Release Tabs to release

Battery Pack from the Charger (or when

removing it from the Impact Driver’s handle).

8. Slide Battery Pack into handle of Impact Driver.

9. Store the Charger indoors, out of reach of children.

WARNING! Do NOT use a different Charger

or Battery to power this Impact Driver.

General Operating Instructions

TO PREVENT SERIOUS INJURY FROM

ACCIDENTAL OPERATION:

Unlock and release the Trigger and disconnect Battery

Pack prior to making any adjustments to the tool.

1. With a charged Battery inserted in Impact

Driver, select appropriate size 1/4” drive

socket. Use only impact Hex-type sockets.

2. Insert the socket into the Locking Collar.

3. Hold socket on the nut that is to be loosened/tightened.

4. Press down on the Direction Switch. Pressing down

on Switch on right side (with the arrow facing front of

the Impact Driver) will activate the Forward direction.

Pressing down on Lever on left side (with arrow facing

away from front) will activate Reverse direction.

5. Once the direction is selected, hold the handle firmly

over the nut and gently squeeze the Trigger, while

keeping the other hand securely on top of housing.

6. Once the Trigger is pressed, the Work

Light (35) will illuminate work area.

7. When the nut is tightened or

loosened, release the Trigger.

8. To prevent accidents, remove Battery Pack from

bottom of Impact Driver and remove socket

from tool. Make sure to store Impact Driver in

a dry, clean location out of reach of children.

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Harbor Freight Tools 12 Volt 1/4 in. Lithium_Ion Cordless Hex Impact Driver Instrukcja Obsługi Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Elektronarzędzia Harbor Freight Tools 12 Volt 1/4 in. Lithium_Ion Cordless Hex Impact Driver