Harbor Freight Tools 1/2 in. Variable Speed Reversible Right Angle Drill Instrukcja Obsługi Pobierz pdf (Strona 10)

Page 10

For technical questions, please call 1-800-444-3353.

Item 97622

Operating Instructions

Read the

ENTIRE

IMPORTANT SAFETY INFORMATION

section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL

OPERATION:

Release the Trigger and unplug the tool from its electrical outlet before adjusting tool or installing bits.

Installing Bits

This Drill is designed to accept drill bits (not included)

with a bit shank diameter from 1/8″ to 1/2″. Do not

use drill bits larger than the capacity of this Drill;

damage to the gears and/or motor may result. Use

a drill bit that is designed for the specific drilling job.

Insert the Chuck Key (24) into the Chuck (43),

and turn the Chuck Key counterclockwise to open

the jaws wide enough to insert the drill bit.

Insert the shank of the drill bit into the Chuck,

and turn the Chuck Key clockwise to secure it.

Changing Speeds

•

The “HIGH” setting on the Speed Switch

runs the Drill at 0 to 1,375 RPM.

•

The “LOW” setting on the Speed Switch

runs the Drill at 0 to 340 RPM.

Before changing speeds, turn the

Trigger (69) to the “OFF” position.

HIGH

LOW

Speed

Switch

(34)

FIGURE C

While rotating the Chuck with one hand,

have the Speed Switch all the way to the

new setting position. (See Figure C.)

NOTICE:

Speed Switch must be completely in the

“UP” or “DOWN” position. Do not set the Speed Switch

while the Drill is running, under a load, or when the tool

is completely stopped. Failure to follow this procedure

can result in damage to the Drill’s internal gears.

Work Piece and Work Area Set Up

Designate a work area that is clean and well-lit.

The work area must not allow access by children

or pets to prevent distraction and injury.

Route the power cord along a safe route to reach

the work area without creating a tripping hazard or

exposing the power cord to possible damage. The

power cord must reach the work area with enough

extra length to allow free movement while working.

Secure loose work pieces using a vise or clamps

(not included) to prevent movement while working.

There must not be objects, such as utility lines,

nearby that will present a hazard while working.

SAFETY OPERATION MAINTENANCESETUP

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Harbor Freight Tools 1/2 in. Variable Speed Reversible Right Angle Drill Instrukcja Obsługi Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Elektronarzędzia Harbor Freight Tools 1/2 in. Variable Speed Reversible Right Angle Drill